Technical Resources for Technical People
Header

If you’re virtualizing DirectAdmin on a XenServer installation, you may wish to add additional ip addresses to the xenserver hypervisor as a gateway before proceeding. However, adding an additional IP to DirectAdmin from a different subnet gateway is also quite similar. Using the DirectAdmin control panel to add a new ip address only works if the …
Read more

Depending on your datacenter allotment of IP addresses, you may be required to use the xenserver hypervisor as a gateway in order to provide different IP subnets to your underlying virtual machines. Our particular installation uses our datacenter “gateway/primary” IP as the xenserver management interface IP address on xenbr0. All other datacenter IP allotments will …
Read more

There are several reasons why you may wish to attach a physical disk to your existing Xenserver installation, in our case we use it for both a permanent storage solution as well as moving large sets of data around (such as copying out virtual disks or data intensive backups). It’ll treat the SATA (or better yet eSATA) …
Read more

Monitoring your RAID array and hard disk health status using SMART should be priority No.1 on any system. Early warnings and preventative maintenance will save you time, money and huge headaches in the long run. It’s always a good practice to order your hard drives at different times or from multiple vendors in order to eliminate the …
Read more

Unlike ESXi, Xenserver doesn’t really have much health monitoring built in (especially not the free license versions). Xenserver has always been the light weight, thin, streamlined and better performing virtualization product; though as time progresses Citrix is slowly adding more features and modifying their licensing structure to be more competitive. But fore now we’ll handle our …
Read more